QX56 AWD V8-5.6L (VK56DE) (2005)
Fluid Pump: Service and Repair
TRANSFER MOTOR
Removal and Installation
REMOVAL
1. Disconnect the transfer motor connector.
2. Remove the air breather hose from the transfer motor.
3. Remove the transfer motor bolts.
4. Remove the transfer motor.
INSTALLATION
1. Apply ATF to the O-ring and install it to the transfer motor.
CAUTION: Do not reuse O-rings.
2. Fit the double-flat end of the transfer motor shaft into the slot of the sub-oil pump assembly. Then tighten to the specified torque.
CAUTION: Be sure to install connector bracket.
3. Install the air breather hose to the transfer motor.
4. Connect the transfer motor connector.
5. Check the transfer fluid.
6. Start the engine for one minute. Then stop the engine and recheck the transfer fluid.