QX56 RWD V8-5.6L (VK56DE) (2006)
2. Heat the panel and double-faced adhesive tape surface to 30 degrees to 40 degrees C (86 degrees to 104 degrees F).
3. Remove the backing sheet from the double-faced adhesive tape surface.
-
Align the plastic clips into the holes in the outer door.
-
Continue aligning the plastic clips into their corresponding holes in the outer door during installation.
4. Press ends by hand and use a roller to apply 5 kg-f (11 lbs-f) to press double-faced adhesive tape surface on side guard molding to door surface.
-
Apply even pressure along double-faced adhesive tape surface on side guard molding to insure proper wet out.
CAUTION: To secure contact of double-faced adhesive tape, do not wash vehicle for 24 hours after installation.