QX56 RWD V8-5.6L (VK56DE) (2006)
/Page-628021.png)
CAUTION: Do not tap pulley on the side surface where the belt is installed (outer circumference).
13. Tighten the crankshaft pulley bolt.
^
Lock the crankshaft using suitable tool, then tighten the bolt.
^
Perform the following steps for angular tightening:
a. Apply engine oil onto the threaded parts of the bolt and seating area.
b. Select the one most visible notch of the four on the bolt flange. Corresponding to the selected notch, put a mating mark (such as paint) on the
crankshaft pulley.
Crankshaft pulley bolt torque
Step 1: 93.1 Nm (9.5 kg-m, 69 ft. lbs.)
Step 2: additional 90° (angle tightening)
14. Rotate the crankshaft pulley in normal direction (clockwise when viewed from engine front) to check for parts interference.
15. Installation of the remaining components is in the reverse order of removal.
