QX56 RWD V8-5.6L (VK56DE) (2006)
Impact Sensor: Service and Repair
Side Air Bag (Satellite) Sensor
SIDE AIR BAG (SATELLITE) SENSOR
Removal and Installation
REMOVAL
CAUTION: Before servicing the SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.
1. Disconnect the negative and positive battery cables, then wait at least 3 minutes.
2. Remove seat belt pre-tensioner.
3. Remove side air bag (satellite) sensor nuts.
4. Disconnect the side air bag (satellite) sensor harness connector.
CAUTION:
-
Do not use old nuts after removal; replace with new nuts.
-
Check side air bag (satellite) sensor to make sure it is free of deformities, dents, cracks or rust. If it shows any visible signs of damage, replace it
with new one.
-
Do not disassemble side air bag (satellite) sensor.
-
Replace side air bag (satellite) sensor if it has been dropped or sustained an impact.
INSTALLATION
Installation is in the reverse order of removal.
-
After the work is completed, perform self-diagnosis to check that no malfunction is detected. Refer to SRS-20, "SRS Operation Check". See:
Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated
Procedures/Manufacturer Code Charts/Air Bag System/Diagnostic Procedures/SRS Operation Check