QX56 RWD V8-5.6L (VK56DE) (2006)
4. Pivot the target board on its center mark 20 degrees to either side.
NOTE: Approx. 50 mm (1.97 in) shift will produce a 20 degrees movement.
5. Remove any items in the shaded space shown in the figure.
NOTE: In case the background space shown in the illustration is not available, or if the background is light colored, place a 400 mm (15.75 in)
long frosted black board or black cloth to both sides of the target board.
Sensor Adjustment
CAUTION:
-
Complete all necessary steps for laser beam adjustment until the CONSULT-II indicates "COMPLETED". If the procedure does not complete, the
ICC system is inoperable.
-
If CONSULT-II is used without connection to the CONSULT-II CONVERTER, malfunctions might be detected during self-diagnosis.
1. Turn ignition switch OFF.
2. Connect CONSULT-II and CONSULT-II CONVERTER to the data link connector.