QX56 RWD V8-5.6L (VK56DE) (2006)
Axle Shaft Assembly: Service and Repair
Disassembly and Assembly
Disassembly and Assembly
DISASSEMBLY
Final Drive Side
1. Mount the drive shaft in a vise.
CAUTION: When mounting the drive shaft in a vise, use copper or aluminum plates between the vise and the drive shaft.
2. Remove the boot bands.
3. If the plug needs to be removed, move the boot to the wheel side, then drive the plug out using a suitable plastic hammer.
4. Remove the stopper ring with a flat-bladed screwdriver as shown, and pull the housing out.
5. Remove the snap ring, then remove the ball cage, steel ball, inner race assembly from the drive shaft.
6. Remove the boot from the drive shaft.
7. Remove any old grease on the housing using paper towels.
Wheel Side
1. Mount the drive shaft in a vise.
CAUTION: When mounting the drive shaft in a vise, use copper or aluminum plates between the vise and the drive shaft.
2. Remove the boot bands. then remove the boot from the joint sub-assembly.
3. Screw a suitable drive shaft puller 30 mm (1.18 inch) or more into the threaded part of the joint sub-assembly. Pull the joint subassembly out of
the drive shaft as shown.
CAUTION:
^
If the joint sub-assembly cannot be removed after five or more attempts, replace the drive shaft and joint subassembly as a set.
^
Align the sliding hammer and drive shaft and remove the joint sub-assembly by pulling directly.
4. Remove the boot from the drive shaft.