QX56 RWD V8-5.6L (VK56DE) (2006)
7. Pull out the wheel hub and bearing assembly for access to remove the rear ABS sensor from the wheel hub and bearing assembly as shown.
^
Inspect the ABS sensor O-ring, replace the ABS sensor assembly if damaged.
^
Clean the ABS sensor hole and mounting surface with a suitable brake cleaner and a clean lint-free shop rag. Be careful that dirt and debris do
not enter the axle bearing area.
^
Apply a coat of suitable grease to the ABS sensor O-ring and mounting hole.
CAUTION: Do not pull on the ABS harness.
8. Remove the wheel hub and bearing assembly.
INSTALLATION
Installation is in the reverse order of removal.
^
Inspect the ABS sensor O-ring, replace the ABS sensor assembly if damaged.
^
Clean the ABS sensor hole and mounting surface with a suitable brake cleaner and a clean lint-free shop rag. Be careful that dirt and debris do not
enter the axle bearing area.
^
Apply a coat of suitable grease to the ABS sensor O-ring and mounting hole.
^
Use a new cotter pin for installation.
^
Use new wheel hub and bearing assembly bolts for installation.