QX56 RWD V8-5.6L (VK56DE) (2006)
Rear Door Window Regulator: Service and Repair
REAR DOOR GLASS AND REGULATOR
Removal and Installation
REAR DOOR GLASS
Removal
1. Remove the rear door finisher.
2. Temporarily reconnect the power window switch.
3. Operate the power window switch to raise/lower the door window until the glass bolts can be seen.
4. Remove the inside seal.
5. Remove the glass run from the partition glass.
6. Remove the partition sash bolt (lower) and screw (upper) to remove the sash.
7. Remove the glass bolts and glass.
Installation
Installation is in the reverse order of removal.
-
Reset the power window limit switch. Refer to "SETTING AFTER INSTALLATION".
Glass bolts : 6.1 N.m (0.62 Kg-m, 54 in-lb)