Rodeo LS 2WD V6-3165cc 3.2L SOHC (6VD1) (1997)
Bleeding Sequence
NOTE: Bleed calipers in the following sequence:
-
Left rear
-
Right rear
-
Left front
-
Right front
Connecting Vinyl Pipe To Bleeder Screw
4. Bleed calipers:
A. Attach a clear plastic bleeder hose to the bleeder valve on the caliper. Submerge the other end of the bleeder hose in a clean container partially
filled with brake fluid.
B. Open the bleeder valve.
C. Have an assistant slowly depress the brake pedal.
D. Close the bleeder valve and release the brake pedal.
E. Wait five seconds.
F. Repeat steps B through E (including the five second waiting period) until the brake pedal feels firm and no air bubbles are observed in the
bleeder hose. Repeat steps A through F for the remaining wheel cylinder and calipers.
Specs:
Torque Bleeder Valve Front and Rear Caliper 7.5 Nm (65 lb.in.)
5. Lower vehicle.
NOTE: Brake fluid level in reservoir and fill to the correct level if necessary. Make sure to replace the master cylinder reservoir cap.