Rodeo LS 2WD V6-3165cc 3.2L SOHC (6VD1) (1997)
their original positions.
^
Apply plastigage to the crank pin.
d. Reinstall the rod caps to their original positions.
^
Tighten the rod caps to 54 Nm (40 ft. lbs.)
NOTE: Do not allow the crankshaft to rotate.
e. Remove the rod caps.
f.
Measure the width of the plastigage and determine the oil clearance. If the oil clearance exceeds the limit, replace the rod bearing as a set.
g. Clean the plastigage from the bearings and the crankshaft pins.