Rodeo LS 2WD V6-3165cc 3.2L SOHC (6VD1) (1997)
Hose/Line HVAC: Service and Repair
Removal and Installation
REMOVAL
Preparation:
Battery ground cable
Discharge and recover refrigerant
1. Radiator grille
2. Clip and clamp
3. Refrigerant liquid line
4. Refrigerant suction line
5. Refrigerant discharge line
-
Use a back-up wrench when disconnecting and reconnecting the refrigerant lines.
-
When removing the refrigerant line connecting part, the connecting part should immediately be plugged or capped to prevent foreign matter
from being mixed into the line.
INSTALLATION
To install, follow the removal steps in the reverse order, noting the following points:
1. O-rings cannot be reused. Always replace with new ones.
2. Be sure to apply new compressor oil to the O-rings when connecting refrigerant lines.
3. Tighten the refrigerant line to the specified torque.