Rodeo LS 2WD V6-3165cc 3.2L SOHC (6VD1) (1997)
Camshaft Position Sensor: Service and Repair
Removal
1. Disconnect the negative battery cable.
2. Disconnect the electrical connector to the CMP sensor.
3. Remove the Camshaft Position (CMP) retaining screw from the left timing belt cover.
4. Remove the CMP sensor from the left timing belt cover.
Installation
1. Install the CMP sensor in the timing belt cover.
2. Install the CMP sensor retaining screw.
-
Tighten the retaining screw to 9 N.m (78 lb in.).
3. Connect the electrical connector to the CMP sensor.
4. Connect the negative battery cable.