Rodeo LS 2WD V6-3165cc 3.2L SOHC (6VD1) (1997)
e. Install seven 13 mm screws.
f.
Install 8.5 mm connector of earth harness under the head of this valve body bolt and reinstall it.
^
Torque 20 Nm (15 ft. lbs.).
g. Remove two guide pins.
2. Servo cover. Install servo cover gasket, cover and four 13 mm screws.
^
Torque 25 Nm (18 ft. lbs.).
3. Wiring harness:
a. Connect harness to band control and shift solenoids.
b. Connect 4 pin connector to main case connector.
4. Manual detent:
a. Install roller and spring assembly.
b. Install two 13 mm screws.
^
Torque 20 Nm (15 ft. lbs.).
5. Oil filter. Install oil filter and three 13 mm screws.
^
Torque 20 Nm (15 ft. lbs.).
6. Main case oil pan:
a. Install oil pan gasket, magnet, oil pan and sixteen 10 mm screws.
^
Torque 11 Nm (96 inch lbs.).
b. Fill transmission through overfill screw hole of oil pan, using ATF DEXRON III.
c. Connect negative (-) battery cable.
Overhaul
TOOLS REQUIRED
^
J-3387-2 Guide Pins
^
Or Equivalent