S-Type (X200) V8-4.0L (AJ28) (2001)
/v8-4.0l_(aj28)/Page-1337007.png)
6.
Using a sharp lead pencil, mark centerline on masking tape (Illustration 7).
7.
Using a sharp lead pencil, Centrally measure and mark 32 mm rearward from top edge of windshield finisher. Centrally, measure and mark off 14
mm rearwards from the 32 mm marked position (Illustration 8).
8.
Carefully drill 3 mm diameter pilot hole through roof panel at previously marked 32 mm position (Illustration 9).
Caution:
Throughout drilling operation take care not to distort outer roof panel.
Note:
