S-Type (X200) V8-4.0L (AJ28) (2001)
37.
Using tie straps secure antenna lead to left hand A-post harness at four places. (Illustration 18)
38.
Cut and remove protruding tales from tie straps.
39.
Place antenna mount/mast assembly to front.
40.
Ensure rubber seal is seated in antenna mount base.
41.
With the aid of another person install new antenna mounting base/mast assembly to outer roof panel.
42.
Tighten antenna lead base connector to mounting base/mast-securing screw (Illustration 19).
43.
Measure 250 mm along new antenna lead from facia end aperture top front corner (Illustration 20).