S-Type (X200) V8-4.0L (AJ28) (2001)
Remove the retaining bolt.
9. NOTE: Left-hand shown, right-hand similar.
Remove the special tool from the exhaust manifold.
-
Remove the retaining bolt.
10. NOTE: Left-hand shown, right-hand similar.
Install the exhaust manifold retaining nut.
-
Tighten to 20 Nm.
11. NOTE: Install a new O-ring seal.
Install the oil level indicator and tube.
-
Tighten to 10 Nm.
12. Install the intake manifold retaining bracket.
1. Attach the engine wiring harness.
2. Install the intake manifold retaining bracket.
-
Tighten the intake manifold retaining bracket retaining bolt to 10 Nm.
-
Tighten the intake manifold retaining bracket retaining nuts to 6 Nm.