S-Type (X200) V8-4.0L (AJ28) (2001)
/v8-4.0l_(aj28)/Page-1486001.png)
Roof Opening Panel Motor: Testing and Inspection
Motor Synchronization
1. NOTE: It may be necessary to slightly separate the rail assembly to visually see the two holes line up.
Align the holes in the mechanism on each side.
2. NOTE: The alignment pins must remain in place until the roof opening panel control module is installed.
Install an alignment pin in the alignment hole in each side of the mechanism.
-
The alignment pin should be approximately 2.83 mm (0.11 in).
