S-Type (X200) V8-4.0L (AJ28) (2001)
^
Apply grease to the worm spindle (worm and drive bar).
^
Install motor to drive bar.
^
Install and tighten motor securing screws.
^
Install the motor gearbox plastic cover.
^
Install and tighten securing screws.
^
Hook the bungee cord to the tray.
^
Refer to GTR section 501-10 and install the seat.
^
Operate the seat to extremes of travel five times.
3.
If there is damage to the worm spindle or bushings, or after carrying out step 2 the fault is still apparent, perform the following:
^
Refer to GTR section 501-10 and remove the affected front seat.
^
Transfer the seat onto a suitable work surface.
^
Unhook bungee cord from tray. (Figure 4)
^
Undo and remove the motor gearbox plastic cover securing screws, and remove the plastic cover. (Figure 5)
^
Undo and remove the gearbox mounting bolts and seat pivot bolt. (Figure 8)
^
Push seat track down (to gain access) and remove the two spindle housing bolts.
^
Remove the front seat height adjustment motor assembly. (Figure 9)
^
Install the new front seat height adjustment motor assembly.
^
Install the gearbox mounting bolts and tighten to 21 Nm (+/- 2 Nm) [15.5 lbf ft (+/- 1.5 lbf ft)].