S-Type (X200) V8-4.0L (AJ28) (2001)
3.4
Check primary junction box connections (located in right-hand side A-post fuse box), as shown in Illustration 9. (Torque tighten to 3.2 Nm
+/- 0.5 Nm) Wiggle block connectors to ensure they are sufficiently clamped to fuse box i.e. tight.
3.4
Check primary junction box connections (located in right-side A-post fuse box) are pushed fully home and are not damaged i.e.
bent/backed-out. Where available, utilize opposing pins from the harness repair kit and insert into populated pins to ensure a good/tight fit is
achieved (Illustration 10).