S-Type (X200) V8-4.0L (AJ28) (2001)
/v8-4.0l_(aj28)/Page-1135008.png)
If no damage is visible proceed to step 34 (install and align new vertical link to upper wishbone) of this workshop procedure.
15.
If the mounting hole is damaged, the lower wishbone will need to be replaced.
On vehicles equipped with 3.0 V6 engines, the generator plastic cover will have to be removed for access if the right hand lower wishbone is to be
replaced and must be reinstalled after completing the alignment check and adjust.
^
Displace and remove generator cover upper fir tree fastener.
^
Loosen and remove generator cover/front under tray securing screw.
^
Loosen and remove generator cover rear securing screw.
^
Remove generator cover.
16.
On all vehicles, loosen, remove and discard stabilizer link arm to lower wishbone-securing nut (Illustration 5). (Hold ball joint stud to stop
rotation.)
17.
Reposition link arm away from lower wishbone.
18.
Loosen and remove front shock absorber to lower wishbone-securing bolt. Discard the nut (Illustration 6).