S-Type (X200) V8-4.2L (2005)
/v8-4.2l/Page-1593013.png)
6. While still holding the glass in the correct position, tighten the front clamp to 8Nm (70lbf in). (Figure 3)
7. Repeat steps 5 & 6 for the rear clamp.
8. Operate door glass to check for full engagement within channel and correct functionality.
9. Reset the operational parameters of the window regulator:
^ Disconnect the window motor connector for a minimum of five seconds to clear the memory.
^ Reconnect the window motor connector.
^ Operate glass to the fully closed position; continue to hold switch in the "up" position for six seconds after closure.
^ Release switch and then hold in the "up" position again for six seconds before releasing
10. Reinstall the water shedder and door casing.
