S-Type (X200) V8-4.2L (2005)
6. While still holding the glass in the correct position, tighten the front clamp to 8Nm (70lbf in). (Figure 3)
7. Repeat steps 5 & 6 for the rear clamp.
8. Operate door glass to check for full engagement within channel and correct functionality.
9. Reset the operational parameters of the window regulator:
^ Disconnect the window motor connector for a minimum of five seconds to clear the memory.
^ Reconnect the window motor connector.
^ Operate glass to the fully closed position; continue to hold switch in the "up" position for six seconds after closure.
^ Release switch and then hold in the "up" position again for six seconds before releasing
10. Reinstall the water shedder and door casing.
Technical Service Bulletin # JTB000573
Date: 100202
Body - Front Door Window Complaints
No: JTB00057
Issue: 3
Date: 02 FEB 2010
ISSUE '3' CHANGES ARE SHOWN WITH A GRAY HIGHLIGHTED BACKGROUND AND/OR ASTERISKS.
SECTION: 501
Front Door Glass - Not Fully Closing / Wind Noise / Judder / Rattle
AFFECTED VEHICLE RANGE:
S-TYPE (X200)
VIN: L00600 - N90324
Model Year: 2000 - 2008
X-TYPE (X400)
VIN: C00344 - E99999
J00001 - J38794
Model Year: 2002 - 2008
CONDITION SUMMARY:
Situation: Various issues have been identified concerning the front door glass:
1. Glass not fully closing.
2. Wind noise from the top edge of the front door glass.