S-Type (X200) V8-4.2L (2005)
/v8-4.2l/Page-1659003.png)
1.
Remove the back section of the remote control key fobs using a suitable thin screwdriver. (Figure 1)
2.
Check for the part number '1X43 15K601 AJ' located on the key fobs. (Figure 2)
3.
If the part number is 1X43 15K601 AJ, no further action is necessary, re-assemble the key fob.
4.
If the part number is NOT 1X43 15K601 AJ, perform the "Install Insulating Foam Pad" section below on affected fobs.
INSTALL INSULATING FOAM PAD
CAUTION:
Cleanliness is required at all times when carrying out the following workshop procedure.
1.
Install the foam pad in each remote to be updated as follows:
