S-Type (X200) V8-4.2L (2005)
/v8-4.2l/Page-1732010.png)
^
Follow all on-screen instructions to complete this task.
^
When the task is completed, exit the current session.
^
Disconnect IDS and the battery charger/power supply.
^
Operate the seat to extremes of travel five times.
25.
If the fault is still apparent on any vehicle, refer to GTR section 510-10 and install a new front seat base.
Procedure 4 - Motor Stepping (Inching)
PROCEDURE 4 - MOTOR STEPPING (INCHING)
NOTE:
This procedure requires IDS DVD105 with the latest Patch Files loaded or later.
CAUTION:
A Midtronics PSC-550 Vehicle Power Supply must be connected to the vehicle battery during diagnosis and module configuration.
1.
If the seat is stepping or juddering during adjustment, update Seat Software for XK (X150) vehicles as follows:
^
Connect the Midtronics PSC-550 power supply to the vehicle battery.
^
Connect IDS to the vehicle and begin a new diagnostic session, by entering the correct VIN for the current vehicle.
^
Follow the IDS prompts to read the vehicle configuration.
^
When prompted Do you wish to read diagnostic trouble codes? select NO and then press 'tick' to continue.
^
When the Content Model is displayed select Vehicle Configuration tab.
^
Select from the menu Set-up and Configuration.
^
Select Seats from the expanded menu.
^
Select Drivers seat calibration or Passenger's seat calibration.
^
Follow all on-screen instructions to complete this task.
^
When the task is completed, exit the current session.
^
Disconnect IDS and the battery charger/power supply.
^
Operate the seat to extremes of travel five times and verify proper operation.
2.
Update Seat Software for S-TYPE and XJ vehicles as follows:
^
Connect the Midtronics PSC-550 power supply to the vehicle battery.
^
Connect IDS to the vehicle and begin a new diagnostic session, by entering the correct VIN for the current vehicle.
^
When prompted Do you wish to read configuration information from the vehicle?, select NO and then press 'tick' to continue.
^
When prompted Vehicle Configuration Confirmation?, select YES and then press 'tick' to continue.
^
When prompted Do you wish to read diagnostic trouble codes?, select NO and then press 'tick' to continue.
^
When the Content Model is displayed select Vehicle Configuration tab.
^
Select from the menu Set-up and Configuration, and then press 'tick' to continue.
^
Select seat calibration, from the menu and then press 'tick' to continue.
^
Follow all on-screen instructions to complete this task.
