S-Type (X200) V8-4.2L (2005)
^
Position the bleed jar base at least 300 mm (12 inch) above the bleed nipple to maintain fluid pressure and prevent air leaking past the bleed
nipple threads.
^
Position the brake caliper with the piston facing down and the bleed nipple at the top.
^
Open the bleed nipple half a turn.
^
Using a suitable tool, fully retract the caliper piston.
^
Close the bleed nipple.
^
Repeat the above procedure twice.
^
Fill up the brake master cylinder reservoir to the MAX mark as necessary.
^
Continue to bleed the caliper using the above procedure until air-free brake fluid is pumped into the jar.
^
Fully tighten the bleed nipple.
17. NOTE: Left-hand shown, right-hand similar.
Install the outer brake pad.
18. NOTE: Left-hand shown, right-hand similar.
Install the brake caliper.
^
Tighten to 28 Nm.
19. NOTE: Left-hand shown, right-hand similar.
Install the brake caliper retaining bolt dust covers.