S-Type (X200) V8-4.2L (2005)
1. WARNING: Do not use compressed air to disperse brake dust into the atmosphere.
CAUTION: Brake pads must always be replaced in axle sets.
CAUTION: Make sure the brake disc faces are clean before installation.
NOTE: Left-hand shown, right-hand similar.
Install the brake pad.
^
Using a suitable tool, fully retract the brake caliper piston.
2. NOTE: Make sure the brake pad is correctly installed to the caliper piston.
NOTE: Left-hand shown, right-hand similar.
Install the brake pad to the caliper piston.
3. NOTE: Left-hand shown, right-hand similar.
Install the brake caliper.
4. NOTE: Left-hand shown, right-hand similar.