S-Type (X200) V8-4.2L (2005)
4. Remove the brake pads.
Installation
1. WARNING: DO NOT USE COMPRESSED AIR TO DISPERSE BRAKE DUST INTO THE ATMOSPHERE.
CAUTION: If the pistons are pushed back into the housing, brake fluid will be forced back into the brake fluid reservoir.
CAUTION: Make sure the brake disc faces are clean before installation.
CAUTION: Brake pads must always be replaced in axle sets.
To install, reverse the removal procedure.
^
Using a suitable tool, fully retract the brake caliper pistons.
^
Install a new brake caliper lower retaining bolt.
^
Tighten to 34 Nm.