S-Type (X200) V8-4.2L (2005)
6. Remove the brake pads.
^
Remove the brake pad anti-rattle spring plates.
Installation
1. WARNING: DO NOT USE A COMPRESSED AIR TO DISPERSE BRAKE DUST INTO THE ATMOSPHERE.
^
CAUTION: If the pistons are pushed back into the housing, brake fluid will be forced back into the brake fluid reservoir.
^
CAUTION: Make sure that the brake disc faces are clean before installation.
^
CAUTION: Brake pads must always be replaced in axle sets.
NOTE: Remove the forcing screw from the crankshaft pulley/damper remover and install to the brake caliper piston retractor tool.
Using the special tools, fully retract the brake caliper pistons.