S-Type (X200) V8-4.2L (2005)
CAUTION: Make sure the brake disc faces are clean before installation. I
CAUTION: Brake pads must always be replaced in axle sets.
To install, reverse the removal procedure.
^
Using a suitable tool, fully retract the brake caliper pistons.
^
Install a new brake caliper lower retaining bolt.
^
Tighten to 34 Nm.
Brake Pads - Vehicles With: Standard Brakes, VIN Range: N52207->N99999
Brake Pads - Vehicles With: Standard Brakes, VIN Range: N52207->N99999 (70.40.02)
Removal
1. Remove both front wheels and tires.
2. NOTE: Left-hand shown, right-hand similar.
Remove the anti-rattle spring.
3. NOTE: Left-hand shown, right-hand similar.
Remove the brake caliper retaining bolt dust covers.
4. CAUTION: Do not allow the brake caliper to hang on the hydraulic hose, as this will damage the hose. Failure to follow this instruction will
result in damage to the hose.
NOTE: Left-hand shown, right-hand similar.
Remove the brake caliper retaining bolts.