S-Type (X200) V8-4.2L (2005)
Installation
1. WARNING: Do not use compressed air to disperse brake dust into the atmosphere.
CAUTION: If the pistons are pushed back into the housing, brake fluid will be forced back into the brake fluid reservoir.
CAUTION: Make sure the brake disc faces are clean before installation.
CAUTION: Brake pads must always be replaced in axle sets.
NOTE: Make sure that the inboard brake pad is correctly installed to the caliper piston.
NOTE: Left-hand shown, right-hand similar. To install, reverse the removal procedure.
Using a suitable tool, fully retract the brake caliper pistons.
^
Tighten to 58 Nm.