S-Type (X200) V8-4.2L (2005)
3. NOTE: Remove the forcing screw from the brake caliper piston retractor tool and install to the crankshaft pulley/damper remover.
NOTE: Left-hand shown, right-hand similar.
Install new brake pads.
^
Install the brake pad anti-rattle spring plates.
4. CAUTION: The brake caliper must be supported at all times.
NOTE: Left-hand shown, right-hand similar.
Remove the tie strap.
5. NOTE: Left-hand shown, right-hand similar.
Attach the caliper.
^
Install new brake caliper retaining bolts.
^
Tighten to 34 Nm.
6. Install both rear wheels and tires.
7. NOTE: Do not start the engine or operate the electronic park brake before depressing the brake pedal.
Repeatedly depress the brake pedal until brake pressure is evident.
Brake Pads - Vehicles With: High Performance Brakes, VIN Range: M45255>N52206
Brake Pads - Vehicles With: High Performance Brakes, VIN Range: M45255>N52206 (70.40.03)
Removal
1. WARNING: BRAKE DUST, IF INHALED CAN DAMAGE YOUR HEALTH. ALWAYS REMOVE BRAKE DUST USING A
VACUUM BRUSH. DO NOT USE A COMPRESSED-AIR LINE TO DISPERSE BRAKE DUST INTO THE ATMOSPHERE. Failure to
follow this instruction may result in personal injury.