S-Type (X200) V8-4.2L (2005)
3. CAUTION: The brake caliper must be supported at all times.
NOTE: Left-hand shown, right-hand similar.
Detach the brake caliper.
^
Remove the brake caliper retaining bolts.
^
Detach the brake caliper.
4. NOTE: Left-hand shown, right-hand similar.
Remove the brake pads.
Installation
1. WARNING: Do not use compressed air to disperse brake dust into the atmosphere.
CAUTION: If the pistons are pushed back into the housing, brake fluid will be forced back into the brake fluid reservoir.
CAUTION: Make sure the brake disc faces are clean before installation.
CAUTION: Brake pads must always be replaced in axle sets.
NOTE: Make sure that the brake pad with the anti-rattle spring is installed to the inboard side of the brake disc. NOTE: Left-hand shown,
right-hand similar. To install, reverse the removal procedure.
Using a suitable tool, fully retract the brake caliper pistons.
^
Tighten to 28 Nm.
2. Tighten to 5 Nm.