S-Type (X200) V8-4.2L (2005)
11. Bleed the caliper.
^
Make sure the bleed tube is firmly attached to the bleed nipple.
^
Submerge the end of the bleed tube in a bleed jar containing a small quantity of approved brake fluid.
^
Position the bleed jar base at least 300 mm (12 inch) above the bleed nipple to maintain fluid pressure and prevent air leaking past the bleed
nipple threads.
^
Position the brake caliper with the piston facing down and the bleed nipple at the top.
^
Open the bleed nipple half a turn.
^
Using the special tool, fully retract the caliper piston.
^
Close the bleed nipple.
^
Repeat the above procedure twice.
^
Fill up the brake master cylinder reservoir to the MAX mark as necessary.
^
Continue to bleed the caliper using the above procedure until air-free brake fluid is pumped into the jar.
^
Fully tighten the bleed nipple.
^
Make sure the piston grooves are aligned to fit the brake pad peg when the caliper is assembled.
12. Install the outer brake pad.
13. Install the brake caliper.
^
Install new brake caliper guide pin retaining bolts.
^
Tighten to 34 Nm.
14. Bleed the braking system.
15. Install the wheels and tires.