S-Type (X200) V8-4.2L (2005)
^
Remove the brake pads.
Installation
All vehicles
1. WARNING: Do not use compressed air to disperse brake dust into the atmosphere.
CAUTION: Brake pads must always be replaced in axle sets.
CAUTION: Make sure the brake disc faces are clean before installation.
NOTE: Make sure that the brake pad with the anti-rattle spring is installed to the inboard side of the brake disc. NOTE: Left-hand shown,
right-hand similar.
Install the brake pads.
^
Using a suitable tool, fully retract the brake caliper pistons.
2. NOTE: Left-hand shown, right-hand similar.
Install the brake caliper retaining bolts.
^
Install the brake caliper.
^
Tighten to 28 Nm.