S-Type (X200) V8-4.2L (2005)
Wheel Speed Sensor: All Technical Service Bulletins
ABS - MIL ON/DTC's C1175/C1165
S206-09
DATE
01/06
S-TYPE
MODEL
2005 MY
S-TYPE
VIN
N13089-N39466
ABS MIL On/DTCs C1175/C1165-
Rear Sensor Lead Incorrect Routing -
Replace/Reroute Lead
Issue:
Some 2005 MY S-TYPE vehicles within the above VIN range, may exhibit a condition where the Anti-lock Brake System (ABS) malfunction indicator
lamp (MIL) is illuminated, with Diagnostic Trouble Code (DTC) C1175 (left-hand rear) or C1165 (right-hand rear) stored. This can be caused by
incorrect routing of the rear ABS sensor lead, causing abrasion of the wire and water ingress.
Action:
In case of a customer complaint of the above condition, install and reroute a new rear ABS sensor lead following the procedure below.
1.
Remove rear wheel (GTR Workshop Manual, section: 204-04).
Caution:
Make sure the ignition is in the "OFF" position before disconnecting the rear wheel speed sensor electrical connector.
2.
Disconnect the rear wheel speed sensor electrical connector (Illustration 1).