S-Type (X200) V8-4.2L (2005)
/v8-4.2l/Page-419015.png)
1. NOTE: Install the valve cover retaining bolts to their positions previously noted.
Install the valve cover retaining bolts.
^
Install new valve cover retaining bolt O-ring seals.
2. Apply bead of silicone gasket sealant or equivalent meeting Jaguar specification on the two places where the cylinder head and front cover join.
^
The application of sealant must be 3mm diameter by 12mm long. Install the valve cover immediately after applying the sealant.
^
The cover should be fitted directly to the head without smearing the sealant or the seals.
3. Install the valve cover.
^
Install new valve cover gaskets.
^
Complete the tightening sequence.
^
Tighten to 12 Nm.
4. Install the ignition coil-on-plugs.
^
Tighten to 5 Nm.
