S-Type (X200) V8-4.2L (2005)
REPAIR the circuit. CLEAR the DTC. TEST the system for normal operation.
G195523t173 : CHECK FOR LOSS OF SCP + TERMINATION WITHIN THE INSTRUMENT CLUSTER
1. Turn the ignition switch to the OFF position.
2. Disconnect the battery negative terminal.
3. Disconnect the IC electrical connector, FC015.
4. Measure the resistance between FC015, pin 020 (Y) and FC014, pin 014 of the IC.
-
Is the resistance 140 to 220 ohms?
-> Yes
Possible intermittent fault. Recheck DTCs.
-> No
INSTALL a new IC. CLEAR the DTC. TEST the system for normal operation.
Front Electronic Module (FEM)
E : THE MODULE DOES NOT RESPOND TO THE JAGUAR APPROVED DIAGNOSTIC TESTER - FRONT ELECTRONIC MODULE
(FEM)
G195523t174 : CHECK FEM FOR DAMAGE
1. Disconnect the FEM electrical connector FH059.
2. INSPECT the FEM for damage.
-
Does the FEM indicate any signs of damage?
-> Yes
INSTALL a new FEM. CLEAR the DTC. TEST the system for normal operation.
-> No
G195523t175 : CHECK THE SCP + FOR SHORT CIRCUIT TO GROUND
1. Turn the ignition switch to the OFF position.
2. Disconnect the battery negative terminal.
3. Measure the resistance between the diagnostic connector FC001 pin 2, (Y) and GROUND.
-
Is the resistance less than 5 ohms?
-> Yes
REPAIR the SCP + circuit. CLEAR the DTC. TEST the system for normal operation.
-> No
G195523t176 : CHECK THE SCP + FOR SHORT CIRCUIT TO BATTERY
1. Turn the ignition switch to the OFF position.
2. Disconnect the battery negative terminal.
3. Measure the resistance between the diagnostic connector FC001 pin 2, (Y) and pin 016, BATTERY.
-
Is the resistance less than 5 ohms?
-> Yes
REPAIR the SCP + circuit. CLEAR the DTC. TEST the system for normal operation.
-> No
G195523t177 : CHECK THE SCP - FOR SHORT CIRCUIT TO GROUND
1. Turn the ignition switch to the OFF position.
2. Disconnect the battery negative terminal.
3. Measure the resistance between the diagnostic connector FC001 pin 10, (U) and GROUND.