S-Type (X200) V8-4.2L (2005)
3. Connect the left-hand fuel sender gauge electrical connector.
4. Connect the transfer module transfer feed tube.
-
Make sure the quick release coupling has latched onto the fuel pump module fuel tube by pulling the tube after the connection has been made.
NOTE: Non federal market vehicles only.
5. Using the special tool, install the fuel pump module locking ring.
-
Install a new O-ring seal.
-
Tighten to 60 Nm.
NOTE: Federal market vehicles only.
6. Install the fuel pump module locking ring.
-
Install a new O-ring seal.
-
Tighten to 4 Nm.