jaguar Workshop Repair Guides

Jaguar Workshop Service and Repair Manuals

Side Air Bag|Removal and Installation|Page 7802 > < Side Air Bag|Removal and Installation|Page 7800
Page 1
background image

Side Air Bag: Service and Repair
Side Air Curtain Module

Side Air Curtain Module

Removal

WARNING:

-

A restraints control module (RCM) only requires replacement if the system has incurred five separate deployments. At no time change
the RCM for less than five separate deployments.

-

Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
Failure to follow this instruction may result in personal injury.

-

Carry a live air bag module with the air bag and trim cover pointed away from your body. This will reduce the risk of injury in the event
of an accidental deployment. Failure to follow this instruction may result in personal injury.

-

Do not set a live air bag module down with the trim cover face down. Failure to follow this instruction may result in personal injury.

-

After deployment, the air bag surface can contain deposits of sodium hydroxide, a product of the gas generant combustion that is
irritating to the skin. Wash your hands with soap and water afterwards. Failure to follow this instruction may result in personal injury.

-

Never probe the connectors on the air bag module. Doing so may result in air bag deployment. Failure to follow this instruction may
result in personal injury.

-

Air bags modules with discolored or damage trim covers must be replaced. Failure to follow this instruction may result in personal
injury.

-

Vehicle sensor orientation is critical for correct system operation. If a vehicle equipped with an air bag SRS is involved in a collision,
inspect the sensor mounting bracket and wiring pigtail for deformation. If damaged, replace the sensor whether or not the air bag is
deployed.

-

To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing
any air bag SRS components. To deplete the backup power supply energy, disconnect the battery ground cable and wait one minute.
Failure to follow this instruction may result in personal injury.

-

Only carry out a system test with the air bag modules fully installed. Failure to follow this instruction may result in personal injury.

NOTE:

-

Repair is made by replacement only.

-

Once the side air curtain module retaining straps have been detached the side air curtain module must be replaced.

1. Reposition the front seat backs to the maximum reclined position.
2. Disconnect the battery ground cable.
3. Remove both A-pillar trim panels.
4. Remove both B-pillar upper trim panels.
5. Remove both C-pillar trims.
6. Remove both sun visors.

NOTE:  Left-hand shown, right-hand similar.

7. Remove the sun visor retaining clip.
8. Remove the overhead console.

9. Detach the rear passenger assist handle retaining screw covers.

Side Air Bag|Removal and Installation|Page 7802 > < Side Air Bag|Removal and Installation|Page 7800