S-Type (X200) V8-4.2L (2005)
/v8-4.2l/Page-1253002.png)
1. Remove power steering fluid cooler.
Vehicles without supercharger
1. NOTE: Left-hand shown, right-hand similar.
Remove power steering fluid cooler.
Installation
1. To install, reverse the removal procedure.
2. Tighten to 7 Nm.
3. Install a new power steering fluid reservoir.
The content of this article/image reflects the changes identified in TSB-ST211-006
1. Replace the power steering reservoir only if any of the following conditions apply:
Reservoir bottle housing is split
Reservoir bottle port is crushed
