S-Type (X200) V8-4.2L (2005)
/v8-4.2l/Page-986001.png)
Fluid - A/T: Service and Repair
Transmission Fluid Level Check
Transmission Fluid Level Check
Special Service Tools
Check
1. The follow steps must be observed before starting the transmission fluid level check.
^
The vehicle must be on a horizontal ramp.
^
The parking brake must be applied.
^
The engine must be running for 2 minutes with the transmission selector lever in the "P" position.
2. Connect the Jaguar Approved Diagnostic System.
3. Make sure the transmission selector lever is in the "P" position.
4. NOTE: Make sure the transmission fluid temperature is below 30°C (86°F) on the Jaguar Approved Diagnostic System.
With the engine running and the foot brake applied, circulate the transmission fluid by:
^
Moving the transmission selector lever to the -R- position
^
Waiting for three seconds.
^
Moving the transmission selector lever to the -D- position
^
Waiting for three seconds.
^
Moving the transmission selector lever to the -P- position
5. Raise and support the vehicle.
6. Remove the transmission undertray.
7. Place a suitable container under the transmission fluid filler plug.
8. WARNING: Make sure that care is exercised near rotating parts. Failure to follow this instruction may result in personal injury.
With the engine running, using the special tool remove the transmission fluid fill plug.
^
Remove and discard the transmission fluid fill plug.
