S-Type (X200) V8-4.2L (2005)
/v8-4.2l/Page-996007.png)
7. Tighten the retaining nut.
8. CAUTION: Make sure the front of the driveshaft does not put an excessive load on the center bearing. Failure to follow this instruction may
result in damage to the vehicle.
CAUTION: Make sure all components are installed to the position they were removed from. Failure to follow this instruction may result in
damage to the vehicle.
Attach the driveshaft to the transmission flange.
^
Tighten to 88 Nm.
9. Carry out a transmission fluid level check.
