S-Type (X200) V8-4.2L (2005)
Flange remover/replacer shaft center 204-267
Flange remover/replacer forcing screw 204-269
Removal
1. Remove the driveshaft.
2. CAUTION: The following step must be carried out to make sure the correct drive pinion flange retaining nut torque is achieved.
Remove the drive pinion flange nut.
^
Match mark the drive pinion nut to the drive pinion flange.
^
Loosen the drive pinion flange nut 180°.
^
Tighten the drive pinion flange nut to the match mark.
^
Note the force required to tighten to the match mark.
^
Remove the drive pinion flange nut.