S-Type (X200) V8-4.2L (2005)
17. Apply cutting lubricant to both sides of the A-pillar glass adhesive.
18. NOTE: Remove the cutting tool blade BTB-WK1SC from the cutting tool BTB-WK10HD. Install the cutting tool side cutting blade
BTB-WK24ZS and the cutting tool controller arm BTB-WK11B to the cutting tool BTBWK10HD.
Set the cutting tool controller arm to 20 mm.
19. NOTE:
-
Right-hand shown, left-hand similar.
-
Start cutting the windshield glass adhesive from the top of the A-pillar downwards.
Using the special tool cut through the A-pillar windshield glass adhesive.
20. Apply cutting lubricant to the top of the windshield glass.
21. Apply protective tape to the top of the windshield glass.
22. NOTE: Start cutting from either corner into the centre and continue the cut all the way through to the other corner. DO NOT cut from each corner
into the centre as the pressure on the centre of the windshield glass could cause breakage.
Using the special tool cut through the top of the windshield glass adhesive.
23. Using the special tool cut through the right-hand side A-pillar remaining adhesive.