S-Type (X200) V8-4.2L SC (2003)
/v8-4.2l_sc/Page-364004.png)
1. Install the new seal to the inner groove on the face of the timing cover.
2. Install the new seal to the outer groove on the face of the timing cover.
2. Apply sealant to the eight joints on the engine face.
^
Sealant beads to be 3 mm diameter and 12 mm long. Cut the nozzle of the sealant tube to produce a 3 mm (0.12 inch) bead. (Install and
tighten the securing bolts within twenty minutes of sealant application).
3. Install the timing cover.
^
Tighten in the sequence shown.
^
Tighten to 13 Nm.
4. NOTE: Check crankshaft pulley and locking ring for damage.
Clean all crankshaft pulley mating faces.
