Vanden Plas L6-4.2L (1982)
Arm Rest: Service and Repair
Front Door Arm Rest
Removing
- Disconnect the battery and remove the screw securing the warning lamp lens to the arm-rest. Slide the lens rearwards and remove the warning lamp
bulb (1. Fig. 38).
- Remove the screw adjacent to the bulb holder securing the rear of the arm-rest to the door (2, Fig 38).
- Remove the screw from beneath front of armrest (3, Fig. 38) and slide top portion of armrest towards rear of door.
- Remove screws securing arm-rest to door; withdraw arm-rest slightly.
- Note fitted position of the two electrical leads and disconnect the leads at the snap connectors.
Refitting
- Connect the warning lamp harness at the snap connectors and feed connectors back into the door casing.
- Position arm-rest on door and secure with the self-tapping screws.
- Refit top portion of arm-rest by sliding it forwards over the two raised screws. Refit the screw to secure upper portion of arm-rest.
- Refit the warning lamp bulb and lens. Reconnect the battery and check the warning lamp for correct operation.