Vanden Plas (X300) L6-4.0L (AJ16) (1996)
Fig.1 Sectional View Hub Assembly
Removal
^ Disconnect vehicle battery ground lead.
^ Slacken appropriate axle shaft hub nut.
^ Support the vehicle at the rear and remove rear road wheel.
Note: To aid assembly, mark the position of the head of the hub carrier fulcrum, relative to the wishbone slot.
^ Disconnect handbrake cable inner and outer.
^ Remove brake caliper, but do not disconnect hydraulics.
^ Slacken hub carrier fulcrum and remove ABS sensor from hub carrier.
^ Remove axle shaft hub nut (and discard), collar and hub carrier fulcrum.
Fig.1
^ Using service tools JD 1D/7 and JD 1D (Fig. 1), push shaft through hub and pull the hub carrier assembly clear.