Vanden Plas (X308) V8-4.0L (AJ27) (2000)
/v8-4.0l_(aj27)/Page-1165014.png)
24. Install crossbeam to engine Hydramount securing bolts.
-
Install bolt securing Hydramount to crossmember and tighten to 22-28 Nm.
-
Repeat procedure to install crossmember opposite side securing bolt.
25. Position and connect harness to steering transducer.
-
RHD vehicles. Position steering harness behind return pipe.
-
Connect harness to transducer.
26. Install power steering pipes on pinion housing.
-
Remove blanks and install new 'O'-ring seals in pipe connectors.
-
Apply power steering fluid to 'O' ring seals.
-
Remove blanking plugs from pinion housing ports.
-
Position pipes on pinion ports and seat 'O' rings.
27. Secure pipes to pinion housing.
-
Ensure pipes and retaining plate are correctly seated.
-
Install bolt and tighten to 9-12 Nm.
