Vanden Plas (X308) V8-4.0L (AJ27) (2000)
/v8-4.0l_(aj27)/Page-1167006.png)
17. NOTE: It may be necessary to use a hammer and drift to finally align new mounting with body location.
Carefully raise crossbeam assembly into position.
Ensure that dowels of both crossbeam mountings seat correctly in body locations.
18. Ensure that both engine hydramounts seat correctly in crossbeam locations.
19. Install crossbeam rear mountings.
Align rear mounting rubber with body location.
Install rear mounting securing bolt and nut and tighten nut to 131 - 185 Nm.
Repeat procedure to install opposite side rear mounting securing bolt and nut.
