Vanden Plas (X308) V8-4.0L (AJ27) (2000)
/v8-4.0l_(aj27)/Page-1170005.png)
Align small void centers with masking tape markers.
10. Install bush in housing.
Position a steel plate over the bush, ensuring the plate is large enough to cover the rubber flange.
Operate the press to install the bush.
11. Ensure bush is fully seated in subframe.
The clearance between the bush flange and subframe must not exceed 1.5 mm.
12. Ensure bush is aligned correctly in subframe as detailed in Step 8 or 9 as appropriate.
13. Wipe off all excess adhesive from subframe and bush, and remove masking tape.
14. NOTE: Allow adhesive at least 30 minutes to cure, before installing subframe on vehicle.
Install suspension subframe on vehicle.
